Immersion Heaters to help Renewable Energy
Immersion Heaters To Help Renewable Energy
Find out how the electric immersion heater could enable almost full renewable electricity supply in the UK
general | news | water | heatingUnlike modern coal and gas power stations,
renewable energy generation cannot be turned on with a switch. If the wind is not blowing,
wind turbines make no electricity, and if it is nighttime or cloudy
solar panels do not. Similarly there are times when demand for power is low, and renewable supply actually exceeds demand and is wasted. If a country is to be
wholly powered by renewable sourced electricity, a way has to be found to balance supply with demand throughout the days and the seasons.
Use Immersion Heaters for Load Control
Dr. Mark Barrett, Principal Research Fellow at the
UCL Energy Institute believes that the 19 million
immersion heaters around the UK could be used to store vast amounts of energy as
hot water. Currently in the UK electricity demand fluctuates between around 20GW and 60GW. 19 million standard 3kW immersion heater elements would take 55GW if all switched on at the same time. By remotely controlling these immersion heater elements, excess renewable capacity could be used to heat water, and then later on when the renewable supply falls, demand for electricity would also be less since people would already have the hot water they need in their tank.
Dr Barrett suggests that all hot water tanks would be kept at above 45 degrees Celcius to ensure that hot water is always available on tap, but would be heated up to as much as 65 degrees Celcius when
excess supply is available. The hot water stored acts to
balance supply and demand and ensures that fickle renewable
power is better absorbed, and that
peak demand is reduced reducing the need to build more fossil fuel power stations.
Dr Barrett will present his research today (18th June 2009) at the House of Commons in meeting during which ways the UK and Europe could have a
100% renewable energy supply at reasonable cost will be discussed.
Ripple Control of Heating Loads
Dr Barrett proposes that the immersion heater elements be turned on and off remotely using
ripple control - a communication system with transmissions sent through the mains electricity supply as high-frequency pulses. These signals would be received by small electronic switches fitted to every
immersion heater element to turn immersion heaters on and off as supply and demand dictates.
Ripple control is to be introduced soon in South Africa where they have been suffering from power cuts for years due to demand exceeding supply. A similar system of
demand side management (or
load control) has been in place and working well in New Zealand for decades now.
Article Last Modified: 14:34, 18th Jun 2009Comment on this Article
If you have any comments on this article, please email them to
neil@reuk.co.uk.
Recommended Related Articles
People who read this article also enjoyed the following articles:
200W 12V Immersion HeaterUsing a wind turbine to heat water for your home via an immersion heater element
Article Last Modified: 13:21, 4th Sep 2008heating | wind | waterSimple Solar Water Preheating SystemUse solar power to pre-heat water and reduce electricity/gas consumption
Article Last Modified: 14:47, 7th Oct 2009solar | heating | waterPermanent Magnet GeneratorBuild a wind or water power system with around a PM Generator
Article Last Modified: 11:44, 21st Jul 2008wind | hydroREUK Poultry Lighting SystemBuy the tried and tested REUK poultry lighting system
Article Last Modified: 15:17, 28th Sep 2009solar | shopping | generalDirect Solar Water Heating SystemFind out how to put together a simple and cost effective direct solar water heating system
Article Last Modified: 14:30, 18th Aug 2009solar | water | heatingBuild a Concentrated Solar Water HeaterPlans for building a cheap advanced solar water heating system
Article Last Modified: 10:14, 12th Apr 2007heating | solar | waterSimple Solar Water HeatingMake a simple solar water heater with easy to find materials
Article Last Modified: 13:17, 30th Jun 2008heating | solar | waterWind Turbine Water HeatingHeat water directly using a wind turbine generator (with or without a battery bank)
Article Last Modified: 13:21, 4th Sep 2008wind | heating | waterThermosyphon Solar Water HeatingFind out how a Thermosyphon Solar Water Heating System works
Article Last Modified: 16:15, 3rd Nov 2008heating | solar | waterImmersion Heater Elements for Wind TurbinesDetails of a range of immersion heater elements designed for use with wind turbine generators
Article Last Modified: 08:19, 22nd Dec 2008wind | heating | water
|
|
|
