Compare Heat Pump to Condensing Boiler
Compare Heat Pump To Condensing Boiler
Should you choose a condensing boiler or an air source / ground source heat pump
geothermal | energy efficiency | heatingIn our articles
Geothermal Heat Pump, and
Air Source Heat Pump we looked at how
heat pumps can be used to heat water (and air) in a building in an efficient manner.
The typical boiler installed in the vast majority of new homes (and now retrofitted to old homes) is the
condensing boiler (aka
condenser boiler) - a very
energy efficient type of gas-powered boiler which runs typically at around
90% efficiency. A condening boiler uses the heat from the
flue gases to pre-heat the water before it enters the boiler - thereby reducing gas consumption. Gas boilers installed before 1990 were typically 60% or less efficient, so changing an old boiler to a
condensing boiler could knock 30+% off your gas bills.
Heat Pump or Condensing Boiler?
With the latest gas powered boilers being so efficient, which is better to use - an air source or ground source heap pump, or a condensing boiler?
In the article
Air Source Heat Pump we introduced the
CoP - the
Coefficient of Performance. This is a measure of the number of units of heating obtained for each unit of electricity consumed by the heat pump. We can work out the CoP at which it makes economic and environmental sense to use a
heat pump (the break even point), and then install a heat pump with a CoP greater than this value in order to reduce
carbon emissions and heating costs.
At break-even point the CO2 emissions per kWh unit of gas (0.193 kg / kWh) divided by the efficiency of the condensing boiler will be
equal to the CO2 emissions per kWh unit of electricity (0.432 kg / kWh) divided by the efficiency (CoP) of the heat pump. Therefore, the break-even point for emissions (assuming a 90% efficient condensing boiler) is:
0.90 * (0.432 / 0.193) = 2.24 CoP
Therefore, if an air-source (or ground-source) heat pump has a CoP of greater than 2.24, it will release
less carbon emmissions than a condensing boiler.
A similar calculation can be carried out on the cost benefits of a heat pump over a condensing boiler, and (at UK prices where gas is less than half the price of electricity per kWh), the break-even CoP is also around 2.2-2.3, i.e. a heat pump with a CoP of > 2.3 will
reduce fuel bills.
The Effect of Ambient Temperature on CoP
The CoP of an
air source heat pump depends on the temperature of the air outside. The colder it is outside, the more electricity is consumed extracting useful heat from it. On a typical mild British spring morning, a typical air-source heat pump will have a CoP of between
3 and 4. At around -15 degrees the CoP will fall below 1 - i.e. it will take more than 1 unit of electricity to generate 1 unit of heat.
The temperature at which a heat pump has a CoP less than the
2.3 break-even point calculated earlier is around 0 degrees Celcius - therefore, in the UK where extended periods with air temperatures below zero are rare, a typical
air-source heat pump will generate
less carbon emissions and cost
less money to run than the best condensing boiler.
The Final Advantage of a Heat Pump
While the latest gas
condensing boilers are ultra-efficient, they depend upon finite fossil fuels. The heat extracted from the air outside (or the ground) by a heat pump is generated by
solar power from the Sun's rays shining on the Earth, and is therefore 'green'. If electricity generated from renewable sources such as
PV solar and
wind is used to power a heat pump (e.g. by
changing your electricity supplier) then your home and water can be heated entirely renewably (and cost effectively).
Article Last Modified: 16:13, 29th Jan 2009Comment on this Article
If you have any comments on this article, please email them to
neil@reuk.co.uk.
Recommended Related Articles
People who read this article also enjoyed the following articles:
Air Source Heat PumpsFind out about using an air source heat pump to heat water in your home
Article Last Modified: 10:27, 31st Mar 2009geothermal | energy efficiency | heatingSimple Solar Water Preheating SystemUse solar power to pre-heat water and reduce electricity/gas consumption
Article Last Modified: 14:47, 7th Oct 2009solar | heating | waterPermanent Magnet GeneratorBuild a wind or water power system with around a PM Generator
Article Last Modified: 11:44, 21st Jul 2008wind | hydroGeothermal Heat PumpFind out about using ground source heat pumps to heat your home
Article Last Modified: 13:57, 29th Jan 2009geothermal | energy efficiencyHow Do PV Solar Panels WorkFind out how photovoltaic solar cells generate electricity
Article Last Modified: 10:14, 10th Jan 2009solar | educationFeed in TariffFind out more about feed in tariffs - the amount you can be paid for exporting renewable electricity to the National Grid
Article Last Modified: 15:01, 16th Jul 2009solar | wind | generalLoft InsulationFind out more about insulating your roof space
Article Last Modified: 17:14, 11th Apr 2009energy efficiency | generalDIY Solar Water Heating PrototypeFollow the construction of a successful DIY solar water heating prototype
Article Last Modified: 15:16, 19th Aug 2008solar | heating | waterGreenhouse Heatsink Connection DiagramPutting together a solar powered greenhouse heatsink
system
Article Last Modified: 10:27, 31st Mar 2009solar | heating | generalFree VAWT Wind Turbine PlansMake your own 250 Watt vertical axis wind turbine (VAWT)
Article Last Modified: 14:47, 17th Feb 2009wind | education
|
|
|
